Skip to main content

Distort

Distort creates a distortion effect where you can control the strength, rotation, and more.

properties

Add Distort

To add a Distort effect:

  1. Go to the Inspector panel.
  2. Click + Add Component.
  3. Go to Post Effect.
  4. Click Post Process.
  5. Under the Post Process property, click Add Effect.
  6. Click Distort.

Properties

PropertyDescription
Barrel PowerThe strength of the distortion. The positive and negative values represent different styles of distortion. Values range between -1.00 and 1.00. See the demonstration below.
RotationThe rotation of the screen. Values range between -360.00 and 360.00. See the demonstration below.
ZoomThe zoom level of the screen. Values range between -1.00 and 1.00.
AmplitudeControls the amplitude of dynamic distortion in x and y directions. See the demonstration below.
FrequencyControls the frequency of a dynamic distortion in x and y directions.
SpeedControls the speed of dynamic distortion in x and y directions. See the demonstration below.
OffsetControls the offset to the distortion center (screen center) in x and y directions for a dynamic distortion.
tip

You must set up non-zero x or y values for Amplitude to see the results of Speed and Frequency values.

Demonstrations

Barrel Power

barrel demo

Rotation

rotation demo

Amplitude

image-0
image-1

Amplitude Y = -0.25

Amplitude Y = 0.35

Speed

image-0
image-1

Speed = 1.00

Speed = 3.00